Thermal Paper Rolls for Epson TM Printers (TM-T88V, TM-T20 and More)
Epson TM receipt printers, including the TM-T88 and TM-T20 series, take 80 x 80mm thermal rolls with a 12.7mm core. No ink, ribbon or toner is needed. The exception is Epson's impact range, such as the TM-U220, which takes 76mm bond paper and an ERC-38 ink ribbon instead.
What size thermal roll does an Epson TM-T88 take?
The Epson TM-T88 takes an 80 x 80mm thermal roll on a 12.7mm core. That is 80mm paper width, an 80mm roll diameter and a 12.7mm centre hole. Every model in the T88 line uses the same paper, so a T88V, a T88VI and an older T88 all take the identical roll.
The width and the core are the two numbers that decide whether a roll fits. Both are fixed on the TM-T88. The diameter is the flexible one. An 80mm printer bay will hold an 80mm roll comfortably, and a smaller diameter still works, it simply runs out sooner. If your till is busy, stay on the full 80mm diameter.
Nothing else goes into the printer. The TM-T88 prints with heat, so there is no ribbon or cartridge to buy. That is the whole consumable list for a TM-T: one roll, nothing more.
Which Epson printers take 80 x 80mm thermal rolls?
Nearly all of them. The whole Epson TM-T thermal family runs on 80 x 80mm rolls, including the TM-T88, TM-T20, TM-T70 and the mobile m30. Epson built the TM-T range around the 80mm standard, so once you know your printer starts with TM-T, you can order 80mm thermal with confidence.
| Epson model | Roll it takes | Notes |
|---|---|---|
| TM-T88 (all versions, including T88V) | 80 x 80mm thermal | One of the most common shop receipt printers |
| TM-T20 series | 80 x 80mm thermal | Popular entry-level EPOS printer |
| TM-T70 | 80 x 80mm thermal | Front-loading unit built into counters |
| TM-m30 series | 80 x 80mm thermal | Compact tablet and mobile EPOS printer |
| TM-U220 (impact) | 76 x 70mm bond, often 2-ply | Kitchen and docket use, needs an ERC-38 ribbon |
Running a mixed shop with other brands on the counter? The sizes for Star, SAM4s and Citizen units are set out in till rolls for Star, SAM4s and Citizen printers. The full brand-by-brand picture sits in the till roll compatibility guide.
Which Epson printers do not take thermal rolls?
Epson's impact printers do not. The TM-U220 is the one most people meet, usually sitting in a kitchen. It prints by striking an ink ribbon against plain bond paper, so it takes 76 x 70mm bond rolls and an ERC-38 ribbon. Put a thermal roll in it and nothing prints.
So the question to settle before you order is simply which Epson is in front of you. A TM-T is thermal and takes one roll. A TM-U is impact and takes two items, the bond roll and the ribbon. The model number on the front of the unit tells you which, and the paper bay label usually repeats it.
- Thermal Epson (TM-T range): 80 x 80mm thermal, no ribbon.
- Impact Epson (TM-U220): 76 x 70mm bond plus an ERC-38 ribbon.
- Not sure which you have? Drag a coin across the paper. A grey mark means thermal.
The choice between the two types for a kitchen is covered in kitchen printer rolls: impact vs thermal, and the ribbon codes are listed in ink ribbons explained.
Rolls that fit your Epson, in stock today
80 x 80mm thermal rolls on a 12.7mm core, by the box, at trade prices with fast Irish delivery from our Cavan warehouse.
Does the core size matter on an Epson roll?
Yes, and it is easy to get right. Epson TM-T printers use a 12.7mm core, which is the standard core on almost every 80mm thermal roll sold in Ireland. A wrong core can rattle or jam in the bay. Check the number on your old roll's box, and if it says 12.7mm you are ordering the same thing.
Core size is one of the three numbers on any roll spec. Width and core have to match your printer. Diameter is your call. A larger diameter holds more paper and buys you fewer roll changes on a busy day, while a smaller one suits a low-volume counter or a compact bay.
How do you load a new roll in an Epson TM printer?
Epson TM-T printers use a drop-in bay, so loading takes seconds. Press the cover release, lift the lid, drop the roll in with the paper feeding from underneath, pull a short tail out over the front edge, then close the lid firmly. The cutter trims the tail and the printer is ready.
Two things trip people up. The first is roll direction. Thermal paper only prints on the coated side, so if the paper feeds off the top of the roll instead of the bottom you get blank receipts. Flip the roll over and try again. The second is a lid that has not clicked shut, which stops the feed. Press both corners of the cover down until you hear it seat.
If a receipt still comes out blank on a printer you know is thermal, the roll itself may be plain bond. Scratch it with a coin. No grey mark means the wrong paper type went in.
Where do you buy Epson till rolls in Ireland?
Shop4Rolls stocks every roll an Epson takes, thermal, bond and 2-ply, along with the ERC ribbons the impact models need. Orders ship from our Cavan warehouse at wholesale prices, with free delivery on qualifying orders. Tell us the model number and we will tell you the roll. Start with thermal till rolls for any TM-T printer.
Frequently asked questions
What thermal paper roll does the Epson TM-T88V take?
The Epson TM-T88V takes an 80 x 80mm thermal roll on a 12.7mm core. That is 80mm paper width, 80mm roll diameter and a 12.7mm centre hole. Every version of the T88 uses the same paper, and no ink, ribbon or toner is needed because the printer prints with heat.
What size roll does an Epson TM-T20 use?
The Epson TM-T20 series uses 80 x 80mm thermal rolls with a 12.7mm core, the same as the TM-T88. All Epson TM-T thermal printers are built around the 80mm standard, so one roll size covers the whole range. Order 80mm thermal and it will fit.
Are all Epson paper roll sizes the same?
Almost. The Epson TM-T thermal range all takes 80 x 80mm on a 12.7mm core. The impact models are the exception. The TM-U220 kitchen printer takes 76 x 70mm bond paper, often 2-ply, plus an ERC-38 ink ribbon. Check whether your printer prints with heat or a ribbon.
Can I use a thermal roll in an Epson TM-U220?
No. The TM-U220 is an impact printer, so it prints by striking an ink ribbon against plain bond paper. A thermal roll produces nothing in it. Use 76 x 70mm bond rolls and an ERC-38 ribbon instead. Many kitchens run 2-ply bond so the pass keeps a copy of each order.
Does a bigger diameter Epson roll still fit?
Yes, up to the size of the paper bay. Width and core are what decide compatibility, so any 80mm roll on a 12.7mm core fits an Epson TM-T. Diameter only sets how much paper is on the roll. A larger diameter means fewer roll changes on a busy till.
Why is my Epson printing blank receipts?
Usually the roll is in upside down. Thermal paper prints on the coated side only, so the paper must feed from underneath the roll, not over the top. Flip it and reload. If it still prints blank, scratch the paper with a coin. No grey mark means it is bond paper, not thermal.
